You’ve stumbled upon the right article if you’re seeking out instructions on how to replace a kitchen faucet. We enjoy sharing tips, tactics, and advice with our customers at Autry Plumbing. There are several factors to consider before upgrading a kitchen sink faucet. To get the optimum result, you must take them all into account.
What kind of faucet can you install in your sink?
Kitchen sinks aren’t all created equal. One-hole, two-hole, three-hole, and four-hole faucets are available for sinks. Get under the sink to see what kind of faucet you should search for at the hardware or plumbing supply store. Make sure you count how many holes there are under the faucet after you get a clear view underneath the sink.
Keep in mind that a one-hole faucet can be used on a four-hole sink. All you have to do now is add a deck plate to hide the extra holes and give the deck a more finished look. However, you can’t do it the opposite way around.
How to Choose a New Faucet
There are a plethora of options available when you’re looking to replace a kitchen faucet. In the end, you’ll want to use the tools to narrow down your search. Do you prefer a single-handle or dual-handle faucet? Is there a dispenser for soap or lotion? How about a hose for spraying?
Of course, there are a plethora of colors, fabrics, and styles to pick from. The list continues on and on: stainless steel, brass, smooth, robust, and so on. Whatever your own taste, there’s a faucet out there for you.
What Is The Best Way To Remove An Existing Faucet?
It’s easy to take off the old faucet. All you’ll need is a basin wrench and a little assistance.
Turn off the water supply line first. After that, you’ll disconnect the supply line from the faucet. While your companion holds the faucet in place above the sink, loosen the bolts underneath with the basin wrench.
The New Faucet Is Being Installed
Clean off any residue or old sealant once the old faucet has been removed. Next, cover the sinkholes with your new deck plate. The plate will be attached with putty or a gasket, depending on the instructions for the faucet.
Grab the new faucet and run the new supply lines down the hole once the plate is in place (s). Using the basin wrench, tighten the washers and nuts underneath the new faucet.
Connect the water line to the supply lines. If feasible, use Teflon tape for the optimum seal. To avoid damaging the pipes or fittings, don’t overtighten the supply lines.
Examining Every Detail
Double-checking for problems is one of the most important aspects of every new installation. Reconnect the water supply line and activate the new faucet.
While the water is running, use a flashlight to keep an eye out for any leaks or problems. Allow at least five minutes for the water to flow to empty the airlines and check for leaks. Tighten, use putty, or seal threads with Teflon tape if you notice any leaks.
Expert Assistance Is Available
In Asheville, NC, Autry Plumbing is your go-to plumbing service. We can assist you with the installation, replacement, repair, and maintenance of your plumbing system. We are trustworthy plumbers who can assist you with all of your plumbing requirements. If you need expert help on your next project, CONTACT us today.
If you enjoyed this post, you may also like: Water Heater Repair & Replacement
Recent Comments